TechniqueSki feedback

All this tuning is for a reason: the skis work perfectly when tuned well and in great shape, otherwise they won't like you, won't like the snow etc. We'll take

Ski feedback

All this tuning is for a reason: the skis work perfectly when tuned well and in great shape, otherwise they won't like you, won't like the snow etc. We'll take a look at some feedback we get from the skis and what this means, how different factors come into play and what to do in different circumstances, to either boots or skis or bindings etc.

There is no single tune for everyone... each will prefer a ski tuned and setup a certain way, because of age, skill even conditions. Finding one's perfect setup and tune is a game of trial and error.

It has been a challenge for me to piece together how to tell what's going on, when to change what, so that's what this post is for, to summarize what I have learned. Please add more, with comments at the bottom.

I will just lay them out for now and start organizing them once I have enough.

Base

A base that is concave (edge high) will make the ski feel railed: the ski wants to go strait and not switch edges. It would be harder and slower to release the ski from a carve.

A base that is convex (center high) will make the ski unstable when going strait. It will also be harder to engage the edges, since that effectively also increases the base bevel.

Edges and bevels

An edge that is too sharp, a big side bevel (i.e. 5) will make the ski harder to get off the edges. It manifests as a "slowness" in getting off the edge or finishing the turn.

A base bevel that is too low (i.e. 0) makes the skis grabby - engage the edges early and stronger. Also better hold on ice. Also makes it harder to get the ski on edge.

A base bevel that is too big (i.e. 2) makes it easier to get the ski on edge. The ski may feel unstable when flat. Grab on ice is reduced.

Waxing issues are always obvious: good, consistent glide versus bad, inconsistent glide,.

An edge that is too sharp at the tip will set into a carve very quickly, most prefer to de-tune that for a bit more progressive and consistent feel. European tuners also seem to prefer progressive base bevels: more at the tip and less underfoot, with more subtle but similar results.

See more under Ski Tuning - edge bevels and Changing the side edge bevel.

Tuning, technique and ski feedback. Source: Head

Bindings

Bindings mounted too far forward will make it easy to initiate and carve any turn, but you can't get power out of the turns. Good for hardpack and ice.

Bindings mounted too far back will cause the skier to use the tails for carving, will make it hard to initiate turns and easier to skid the tails. Good for a powder day, soft snow.

One advantage of the Atomic X-Race binding system is that it can easily slide back and forth at the flip of a switch, making it easy to experiment with binding positioning and snow conditions.

See more under: Mounting the ski bindings forward or central.

Boots and feedback

If the ski chatters on hard snow, it is sign that the boot cuffs are too aggressive (in) or possibly over canted. We call this type of setup aggressive.

If, on the other hand, you feel that you have to angulate more than usual over the outside ski, or pushing the outside knee to the inside too much compared what would normally be needed you need more canting

These are easily observable with video, see External cues vs internal cues in skiing.

Another effect of an aggressive setup is double turning, where the ski grabs earlier and stronger than expected, the skier reacts to reduce pressure and the ski releases, only to engage again - resulting in a sort of a wobble. Double turning is quite visible on the WC right now - most skiers use aggressive setups.

0 views

Updated by razie · version 4